Our equipment is located in the machine room next to the lift control station and is connected via a flexible loop to the lift cabin, where an intercom system is pre-installed.

By switching the lift power supply on and off, a magnetic starter ‘Lifticon-3 GSM’ one control channel ‘Lifticon-8 GSM’ two control channels is installed on the electrical input.

Using a mobile phone or personal computer.

Yes, our specialists will install a door opening sensor. In case of intrusion into the premises, the dispatcher receives SMS messages, if connected to the phone or in the form of an alert on the computer.

We have developed intercoms that are quite difficult to break, damage and scratch. The steel case is covered with hammer paint, the button is made of stainless steel.

We produce two types of blocks ‘Lifticon-3 GSM’ for three intercoms ‘Lifticon-8 GSM’ for 8 intercoms they can be installed anywhere, including in lifts.

Our units are equipped with a rechargeable battery and maintain communication for another 24 hours after a power failure, when the power supply is restored, the battery will recharge again.

Our programmers have written software specifically for working with Lifticon GSM equipment. With a convenient and simple interface and event archive recording.

‘Lifticon-3 GSM"- three alarms, one phase reversal, interface rs-485 “Lifticon-8 GSM”- eight alarms, two phase reversals and two temperature sensors, interface rs-485

Such as lift control station alarm, car door control, lift in fire mode, door opening, flood sensor, fire, gas alarm, critical temperature upper lower limit, pump alarm and many other dry contact based alarms.